IEC60335-1 figure 7 figernail test probe
IEC60335-1 figure 7 figernail test probe Introduction:
Test fingernail probe is made according to GB4706.1-2005,IEC60335-1 and UL standards.It is mainly used to check whether the undetachable parts of electric shock or contact moving parts can withstand the mechanical stress in normal use, to reach the required level of protection test.
Specification
1 Model: P-FN
2 Test fingernail component(three parts):fingertip, middle finger, finger seat
3 Pressure: 50N
4 Reference standard: GB4706.1-2005 figure 7, IEC60335-1 figure 7
The surface pressure 10N on the scratch test, material scraped surface can not be separated.Using
the test finger insert any gap or joint,and then impose vertically a 10N side draw in ,but can not be
twisted and pried, the related components can not be fell off or be damaged.Using the test finger
insert any gap or joint, and impose 10N side draw in the direction of disassembly of the component,
but can not be twisted and pried, the related components can not be fell off or be damaged.
Other test probes:
IP1X, IP2X, IP3X, IP4X
Except of the probes, Guangdong Yuanyao Test Equipment also can supply other test equipment:
Temp. humi. chamber, indurtrial oven, vacuum oven, thermal shock chamber, rapid temp. rate change chamber,
vibration tester, drop tester, sunshine radiation test chamber, etc.
More information, please send the message to us for the equipment inquiry.
Thanks for your patient reading and attention!
Audited Supplier 
){kind=link}
){kind=link}